THE CLOCKWORK VAULT
A print-and-cut handout pack from Dungeon Mechanica

Original, system-neutral tabletop accessory. Not affiliated with any game publisher.

What's in this pack
- clockwork-vault-complete.pdf — 8 US Letter pages. The first three pages are for the game master. Keep them behind the screen.
- clockwork-vault-players.pdf — 5 US Letter pages, the same as complete-pack pages 4–8, with no game-master material.

How to print
Use US Letter (8.5 x 11 inches), portrait, single-sided, at 100% / Actual Size. Turn off Fit, Shrink, Booklet, and two-sided printing. Color is recommended for the wanted poster and the brass registration dots. Warm cream or parchment paper is optional.

The reader
The message plate is complete-pack page 6 / player page 3. The cut-out overlay is the page after that. Print both at the same scale. Use opaque cardstock for the overlay, about 160–220 gsm if your printer allows it. Do not mount the overlay to thick board: it makes the openings harder to look through.

Cut the outside dashed square (4.72 x 4.72 inches) and all twelve dashed circles. A craft knife and cutting mat work well; a 3/8-inch punch is acceptable if it is accurately centered. Adult supervision is needed for sharp tools.

Do not cut the four small solid brass corner dots — those are for lining the sheets up. Leave the backing plate untrimmed. Keep both headings upright, place the overlay directly against the plate, and match all four dots (I to I through IV to IV). Read the exposed type left to right, then top to bottom.

No trimming is needed for the other props. If you trim the edges, stay outside all printed matter, and do not cut the message grid or its corner dots.

You may print these files for your own table. Please do not resell or republish them.
